Programmable functions
58
Adjusting the dryer's
electronics for very soft water
This programmable function
should only be altered if the water is
so soft that it is likely to cause the
electronics which sense residual
moisture in the laundry to give false
readings.
Important
This programmable function should only
be set if the water used for washing the
laundry is extremely soft with a
conductivity reading (electrical
conductivity) less than 150 μS. Contact
your local water authority for the
conductivity level of your mains water
supply.
Only activate this programmable
function if these conditions are
present. Otherwise drying results will
be unsatisfactory.
Follow steps (,, ...) to
programme and store in memory.
Before you begin, ensure the
following:
– The tumble dryer is switched off.
– The door is closed.
– The programme selector is pointing
to Finish.
Press the Start button and keep it
pressed in whilst carrying out steps
-.
Switch the tumble dryer on.
Wait until the indicator light for the
Start button lights up constantly . . .
. . . and then release the Start button.
Turn the programme selector toCool
air.
The Empty the container indicator light
will flash on and off slowly once and
then on and off quickly twice.
The option selected will be displayed
by a number which will alternate with
.
Factory default
Adjusted for very soft water (with
low conductivity)
(The Clean out airways indicator light
will also flash once)
Pressing the Start button switches
between the options.
Switch the tumble dryer off.
The setting you have selected is now
stored in memory. You can change it
again at any time.
To check the setting:
Carry out steps -.
Switch the dryer off after checking
the indicator lights.
To Next Page
Need help?
General
Weight and Dimensions
