Installation and connection
41
Electrical connection
This tumble dryer is supplied with a
mains cable with moulded plug.
The accessibility of the plug must be
always ensured in order to separate the
tumble dryer from the mains.
Connection of this appliance should
comply with national and local safety
regulations.
Do not connect the appliance via an
extension lead. Extension leads do not
guarantee the required safety of the
appliance (e.g. danger of overheating).
The appliance should be connected up
only by a qualified electrician in
accordance with national and local
safety regulations. For extra safety, it is
advisable to install a residual current
device (RCD) with a trip current of 30
mA.
The voltage, rated load and plug rating
are given on the data plate. Please
ensure that these match the household
mains supply.
Important
The wires in the mains lead are
coloured in accordance with the
following code:
Green/yellow = earth
Blue = neutral
Brown = live
As the colours of the wires in the mains
lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows: The wire which is
coloured green and yellow must be
connected to the terminal in the plug
which is marked with the letter E or by
the earth symbol or coloured green or
green and yellow. The wire which is
coloured blue must be connected to the
terminal which is marked with the letter
N or coloured black. The wire which is
coloured brown must be connected to
the terminal which is marked with the
letter A or coloured red.
WARNING
THIS APPLIANCE MUST BE
EARTHED
To Next Page
Loading...
Need help?
General
Weight and Dimensions
