Problem solving guide
30
Problem solving guide
With the help of the following notes minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting Miele.
Please note that a call-out charge will be applied to service visits where the
problem could have been rectified as described in these operating instructions.
Repair work to electrical appliances should only be carried out by an
authorised Miele service technician. Repairs and other work by unqualified
persons could be dangerous. Miele cannot be held liable for unauthorised work.
Check and fault messages
Problem Possible cause and remedy
The Empty the
container indicator
lights up. The
programme is
cancelled, the buzzer
sounds.
The condensed water container is full or there is a
kink in the drain hose.
Empty out the condensed water container.
Check the drain hose.
Open and close the door while the dryer is
switched on. The indicator light will go out.
The programme is
cancelled.
The buzzer may sound
and the Clean out
airways or Empty the
container indicator
flashes.
There is no obvious cause.
Switch the dryer off and then on again.
Start a programme.
If the programme is cancelled again and an error
message appears, there is a fault. Contact Miele.
The programme is
cancelled, lights up
This is not a fault.
In some programmes, if the drum has been
underloaded or is empty, the programme will be
cancelled. This can also happen if the items are
already dry.
Open and close the door to resume drying.
Use the Warm air programme (timed drying) to dry
individual items.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
