Settings
114
Suds cooling
When this is activated, additional
water flows into the drum at the end of
the main wash to cool the suds down.
Hot suds can damage plastic drainage
pipes.
Suds cooling takes place when a
temperature of 70°C or higher is
selected for the Cottons programme.
Suds cooling should be activated:
– to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– where drainage pipes do not comply
with DIN 1986.
Factory default setting: Suds cooling is
switched off.
Low water pressure
If the water pressure is below 100 kPa
the washer-dryer will stop the
programme and an error message will
appear in the display.
This setting can be activated to ensure
problem free water intake where the
water pressure is constantly low (below
100 kPa).
Factory default setting: Low water
pressure is switched off.
Distribution controller
The maximum final spin speed can be
limited to prevent laundry forming a
ring around the drum. This setting is
only effective when washing and
drying in a continuous sequence.
Options
– 1200 rpm (factory setting)
– 1100 rpm
– 1000 rpm
– 900 rpm
Drying levels
You can adjust the drying levels in the
Cottons, Minimum iron and Automatic
programmes.
The drying level is shown in a bar chart:
– Less bars = damper
– More bars = drier
To Next Page
Loading...
Need help?
General
