Cleaning and care
78
Cleaning the water inlet filter
This washer-dryer has a filter to protect
the water inlet valve. The filter in the
union in the open end of the inlet hose
should be replaced every 6 months or
so, or more often if there are frequent
interruptions to the water supply.
First turn off the stopcock.
Unscrew the inlet hose from the
stopcock.
Remove the rubber seal 1 from the
recess.
Hold the free end of the inlet hose
downwards. Plastic filter 2 will drop
out.
Clean the plastic filter.
Put the filter and seal back in the
reverse order and reconnect the
hose.
Turn on the stopcock and check the
connection is watertight. If water
drips out, tighten the connection.
The filter must be put back in place
after cleaning.
To Next Page
Loading...
Need help?
General
