WASHING
43
= Low water level
= Medium water level
= High water level
= Intensive rhythm
= Normal rhythm
= Sensitive rhythm
= Ultra sensitive rhythm
= Handwash rhythm
= Carried out
– = Not carried out
The washer-dryer has fully electronic
controls with automatic load
recognition. It takes in the right amount
of water required for the programme
depending on the amount of laundry
and its absorbency rate.
The programme sequences shown in
the chart are based on the standard
programme with a full load. Extra
options which can be selected have not
been taken into account.
The washer-dryer's display continually
shows which stage of the programme
has been reached.
Special features in the programme
sequence
Anti-crease
At the end of the programme the drum
continues to turn at intervals for up to
30minutes to help prevent creasing.
Exception: There is no anti-crease
phase in the Woollens and Silks
programmes.
The door can be opened at any time
during the anti-crease phase.
1)
If a temperature of 60°C or higher is
selected, or with and
temperatures, 2 rinses are carried out.
If a temperature of less than 60°C is
selected, 3 rinses are carried out.
2)
An additional rinse is carried out if:
– there is too much foam in the drum
– a spin speed lower than 700 rpm has
been selected
– 0 rpm (without spin) has been
selected.
3)
Pre-rinse: a pre-rinse is automatically
carried out to remove dust.
4)
Run-up to spin: a run-up to spin is
carried out before the wash process
begins to deflate the pillows.
5)
Extra rinse: an extra rinse is carried
out when the Water plus option is
selected, if an extra rinse has been
activated as described in "Settings".
To Next Page
Loading...
Need help?
General
