What to do if...
82
A message appears in the display at the end of the programme
Message Cause and remedy
Check dosage
Excessive foam has built up during washing.
Check the amount of detergent dispensed.
With automatic detergent dispensing check the
dosage amount set.
Observe the instructions on the detergent
packaging and the degree of soiling of the laundry.
If necessary, reduce the dosage amount by
increments of 10%.
Align the machine
The smoothing process which the laundry undergoes
at the end of the programme could not be carried out
properly.
Check that the washer-dryer is aligned correctly as
described in "Installation and connection -
Levelling the machine".
Check whether the maximum delivery height of 1.0
m has been exceeded.
If the fault message appears again, contact your
Miele dealer. The washer-dryer can still be used but
with reduced functionality.
Check load
There is no laundry in the drum.
The load is too small. The laundry is still damp
because the residual moisture content in the laundry
could not be measured.
In future use a Timed drying programme for small
amounts of laundry.
The amount of laundry exceeded the max. load for
the selected programme.
Observe the maximum loads given in the
Programme chart.
The messages will appear at the end of the programme and when the washer-
dryer is switched on and need to be confirmed with the OK sensor.
To Next Page
Loading...
Need help?
General
