Installation and connection
101
Water intake
The washer-dryer should be connected
to a mains water supply in accordance
with current local and national safety
regulations. It must be installed
according to AS/NZS 3500.1. Backflow
prevention is already integrated in the
appliance.
The flow pressure must amount to a
minimum of 100kPa (1bar) and must
not exceed an overpressure of
1000kPa (10bar). If it is higher than
1000kPa, a pressure reduction valve
must be installed.
Connection to the mains water supply
should incorporate a water tap with a
¾“ threaded union. The tap should be
fitted by a qualified plumber.
The connection point is subject
to mains water pressure.
Turn on the tap slowly and check for
leaks. Correct the position of the
washer and union if necessary.
The washer-dryer is not suitable for
connection to a hot water supply.
Maintenance
Only use a genuine Miele hose that has
been pressure tested to withstand at
least 14,000kPa should you ever need
a replacement.
In order to protect the water inlet
valve, the dirt filter in the union nut at
the open end of the inlet hose must
not be removed.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
