Installation and connection
96
Installation surface
A concrete floor is the most suitable
installation surface. It is far less prone
to vibration during the spin cycle than
wooden floorboards or a carpeted
surface.
Please note:
The washer-dryer must be level and
securely positioned.
To avoid vibrations during spinning
the washer-dryer must not be
installed on soft floor coverings.
If installing on a wooden joist floor:
We recommend a plywood base (at
least 59x60x3 cm). The base should
span several joists and be bolted to
the joists and not only to the
floorboards. Check for the presence
of pipes and cables first.
Useful tip: If possible, install the
machine in a corner. This is usually the
most stable part of the floor.
Carrying the washer-dryer to
its installation site
Make sure the fixings at the back
of the lid are secure. They may
become brittle due to external
circumstances.
There is a danger of the lid being
pulled off when carrying the
appliance.
Before carrying the appliance, check
that the lid is secure where it
protrudes at the back.
Carry the washer-dryer by the front
feet and by the lid where it protrudes
at the back of the appliance.
Removing the transit bars
Remove the left and right covers.
1. Pull off the transit bar covers and
2. then use a screwdriver to release the
catches at the top and bottom.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
