Settings
118
Remote control
The Remote control setting is only
visible when the Wi-Fi module is fitted
and signed on.
Once the Miele@mobile App has been
installed on your mobile device, you
can check the status of your washer-
dryer from anywhere and start it
remotely.
The Remote control setting has to be
switched on if you want to start your
washer-dryer with your mobile device.
If Remote control is not switched on the
App can cause the programme to be
cancelled.
Use the Delay start sensor to set a time
by when you want to start the washer-
dryer (see “Delay start/SmartStart”).
The washer-dryer will then start within
the specified timeframe when it receives
your signal.
If no start signal is given by the latest
start time set, the washer-dryer will
start automatically.
Remote control is switched off by
default.
SmartGrid
The SmartGrid setting (available
depending on country) is only visible
when the Wi-Fi module is fitted and
signed on.
This function can be used for starting
your washer-dryer automatically at a
time when energy costs are more
economical.
Activating SmartGrid gives the Delay
start sensor a new function.
Set the SmartStart using the Delay Start
sensor (see “Delay Start/SmartStart”).
The washer-dryer will then start within
the timeframe specified when it receives
a signal from the energy supplier.
If it has not received a signal from the
energy supplier by the latest start time
set, the washer-dryer will start
automatically.
The SmartGrid function is switched off
in the default setting.
SmartStart
If you have activated the SmartGrid
function in Settings, instead of Start in,
SmartStart will appear in the display
when you press the Delay start button.
You can define a time period (from 15
minutes to 24 hours), in which the wash
programme must be started. The
procedure for setting this is the same as
for setting the time for Delay start.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
