Miele WTZH 730 WPM User Manual

Problem solving guide
80
Fault messages after a programme has been cancelled
Problem Possible cause and remedy
 Water intake See

The water inlet is blocked or restricted.
 Check whether the tap is turned on properly.
 Check whether the inlet hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
 Clean the filter.
 Check drainage See

The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 Check whether the maximum delivery height of
1m has been exceeded.
  Service
Waterproof syst.
The water protection system has reacted.
 Turn off the tap.
 Call Miele.
  Service Fault F
There is a fault.
 Restart the programme.
 If the fault message appears again, contact Miele.
To switch off the fault message, switch the washer-dryer off with the  button.

Miele WTZH 730 WPM Specifications

General

Current	10 A
Connected load	2400 W
AC input voltage	220-240 V
AC input frequency	50 Hz
Water consumption per cycle	105 L
Water consumption washing per cycle	- L
Energy consumption washing per cycle	5.36 kWh
Door hinge	Right
Control type	Buttons, Rotary
Display type	LED
Loading type	Front-load
Product color	White
Built-in display	Yes
Appliance placement	Freestanding
Half-load	-
Drum capacity	8 kg
Drying system	Steam
Drying capacity	5 kg
Maximum spin speed	1600 RPM
Noise level (spin)	72 dB
Noise level (wash)	46 dB
Noise level (drying)	58 dB
Cord length	2 m
Annual water consumption washing	11400 L
Annual energy consumption washing	220 kWh
Annual water consumption washing & drying	21000 L
Annual energy consumption washing & drying	1072 kWh

Weight and Dimensions

Depth	714 mm
Width	596 mm
Height	850 mm
Weight	102000 g
Depth with door open	1132 mm