Passport 12/Passport 8 23-5
23.6.2.2 Setting the Wireless Network
To set the wireless network:
1. Select [Main Menu]→[Maintenance>>]→[User Maintenance>>]→enter the required password→select [Ok].
2. Select [Network Setup >>].
3. Select [Monitor Network Setup >>].
4. Set [Network Type] to [WLAN].
5. Set the desired [Address Type].
[Manual] : Indicates that the operator will manually enter network settings including IP Address, Subnet Mask,
Gateway.
[DHCP]: Indicates that the monitor will automatically acquire network settings from a DHCP server.
6. Select [WLAN Setup >>] to enter the [WLAN Setup] menu.
7. Enter a network name (SSID).
8. Select a security mode from the [Security] drop-down list and configure the items.
[WEP_OFF], [WPA-PSK], [WPA2-PSK]: When you select one of these security modes, you need to enter a
password for the wireless network.
[WEP_ON] : When you select this security mode, you need to configure [Password], [Key Index], and[AUT.
Type].
[WPA_TKIP], [WPA2_AES], [CCKM_TKIP], [CCKM_AES], [WPA_PSK_AES], [WPA_AES]: These security modes
are Wi-Fi Protected Access (WPA/WPA2) enterprise encryption modes. When you select one of these security
modes, you need to configure additional items such as [EAP Method], [AUT. Protocol], [Identity],
[Anonymity], and [CA Certificate]. You need to import the desired certificate to the monitor before you can
select a certificate. For how to manage certificates, see 23.6.3 Certificates Maintenance.
9. Select [Ok].
23.6.2.3 Setting the WLAN Band and Channels
The monitor supports 2.4 G and 5G WLAN. To set WLAN band rate and channels:
1. Select [Main Menu]→[Maintenance>>]→[User Maintenance>>]→enter the required password→select [Ok].
2. Select [Network Setup >>].
3. Select [WLAN Setup >>].
4. Set [WLAN Band] to [Auto], [5G], or [2.4G] according to the band you are using. Auto is the default, indicating that
the monitor can automatically identify the WLAN band.
5. Select [AUT. Server Type] to set the type of authentication server. The options are ACS and SBR.
6. Select [BG Channel] to set the type of B and G channels. The options are All, Specified, and None. When you select
[Specified], you need to enter the desired channel.
7. Select [A Channel] to set the type of A channel. The options are All, Specified, and None. When you select
[Specified], you need to enter the desired channel.
To Next Page
Loading...
Need help?
General
