Barcode Reader C-1
Appendix C Barcode Reader
The product supports two kinds of readers for logging data as patient ID: 1-D barcode reader (SYMBOL
LS2208) and 2-D barcode reader (SYMBOL DS4308).
The laser transmitted by SYMBOL LS2208 is Class 2 laser.
SYMBOL DS4308 is classified as “EXEMPT RISK GROUP” according to IEC 62471:2006 and EN
62471:2008.
Class 2 laser adopts low power, visible LED. DO NOT stare into beam
because of unknown hazards of transient radiation provided by class 2
laser.
DO NOT stare into beam emitted by SYMBOL DS4308 for more than 10s.
Ensure the information acquired by barcode reader is consistent with
the actual information.
NOTE: the reader does not support decoding of Multilanguage.
C.1 1-D Barcode Reader
There are 2 operation modes for 1-D barcode readers:
Hand-held mode: press the trigger to decode.
Hands-free mode: seat the reader in the stand to enter the mode, the reader decodes automatically.
C.1.1 Overview
Green: A barcode was successfully decoded.
Red: A data transmission error or reader malfunction occurred.
C.1.2 Setting Up the Reader (Take LS2208 as an example)
1. Plug the interface cable modular connector into the cable interface port on the bottom of the reader
handle, and ensure the connector is properly secured.
To Next Page
Loading...
Need help?
General
