System Preparation 3-5
3.3 Connecting the Power Cord
This system can work normally only when it is connected to the external power supply or the
battery capacity is sufficient.
3.3.1 Connecting Power
1. Connect the connector of the power adapter to the adapter port in the system.
2. Use a three-wire cable to connect the adapter with the external power supply.
3. The external power supply must meet the requirements in chapter "2.3.2 Power supply”.
If you have any question about the power adapter, please contact your sales representative.
You must use the specified power adapter.
Do not use this power adapter in conditions other than those specified.
3.3.2 Powered by Batteries
When connecting to the external power supply, the system is powered by the external power.
The lithium ion batteries inside it are in the charging status.
If disconnected from the external power supply, the system is powered by the lithium ion
batteries. Refer to “Appendix B Battery” for the detailed operations and precautions.
To Next Page
Loading...
Need help?
General
