Mitel 622 DECT User Manual

100 Mitel 622 DECT Phone
eud-1720/1.0 – R3.0 – 08.2015
Installation and first-time operation
Connecting a cordless phone
Connecting the charging unit
The phone can be operated without modifying the charging unit.
1. Plug the cable connector into the socket on the underside of the charging unit.
2. Feed the cable through the strain relief provided.
3. Plug the plug-in power adapter into an available socket outlet.
Power supply / Plug-in power supply unit
The power supply unit is rated for 100 V to 240 V AC (50-60 Hz). It is supplied with four
interchangeable adapters, which means it can be used more or less worldwide. Where
necessary, fit the standard adapter head for your country to the power supply unit. As the
plug-in power supply unit comes in two variants, the assembly differs slightly:
• Variant 1: Set the switch on the power supply unit to OPEN and slide the existing
adapter head upwards and out. Next fit the new adapter head to the power supply unit
and lock it into place using the switch (LOCK).
• Variant 2: First remove any adapter head that may already be fitted by pressing OPEN.
Next fit the new adapter head onto the power supply unit at a slight angle with the end
marked TOP at the top. Press it down until it clicks into place.
Software
New phone software can simply be updated during operation using automatic firmware
updates, reducing maintenance costs as a result.
Note:
The plug designs vary from country to country.
Note:
The charging unit and plug-in power supply vary from country to country.

Mitel 622 DECT Specifications

General

Brand	Mitel
Model	622 DECT
Category	Cordless Telephone
Language	English