Mitel SMB Controller User Manual

158
I
NSTALLING, POWERING, CONNECTING AND REGISTERING TERMINALS
CHAPTER 4 INSTALLATION
Connecting the phone
1.
Stick the connector on the longer, straight end of the handset cord on the underside of the phone
into the socket with the handset symbol until it snaps into place. Feed the cable through the strain
relief and connect the other end to the handset.
2. Feed the small connector of the phone connection cable on the rear side of the phone into the
socket until it snaps into place. Stick the connector on the other end into the phone cord.
Preparing the phone for message waiting indication (MWI)
The phone can detect various types of notifications (polarity reversal, high voltage and frequency shift
keying (FSK). The notification type is set with the MWI switch on the underside of the phone. "0" = Off,
"HV" = High voltage, "−/+" = Polarity reversal. The notification type Frequency reversal (FSK) is always
active, regardless of the switch setting (Mitel\ 6730 Analogue only).
The MiVoice Office 400 communication servers support the following notification types (Parameter MWI
mode configurable for each FXS Interface separately):
Tip for the setting polarity reversal:
Set the switch of the phone (e. g. Mitel 6730 Analogue) to the symbol "−". If the MWI LED is blinking when
a message is available and off when no message is available, the switch is set correctly. If the MWI LED
is on when a message is available and blinking when no message is available the switch must be set to
“+”.
NOTE:
• For the notification type FSK, a new message with a small envelope is displayed on the screen of the
phone Mitel 6730 Analogue. This variant is not recommended as the symbol can be easily over-
looked.
• The information in this section basically applies to analogue phones Aastra 1910 and Aastra 1930
too. In these models the MWI switch is labelled on the rear side of the phone, and the switch
settings for polarity reversal, with PR1 and PR2.
• The notification type Low voltage is also supported (used for other analogue phones, especially in
USA and Canada).
Mounting the phone on the desktop
Feed the mounting feet into the corresponding cut-outs on the underside of the phone until they engage.
4 different set-up angles are possible, by choosing the cut-outs and turning the set-up feet.
Table 4.47:Supported notification types
Notification type MWI switch
setting
Mitel 415/430 Mitel SMBC Mitel 470
Switched off 0
Polarity reversal − and + – yes yes
High voltage HV – yes –
Frequency
reversal (FSK)
No symbol(Any
switch setting)
yes yes yes

Mitel SMB Controller Specifications

General

Brand	Mitel
Model	SMB Controller
Category	Controller
Language	English