201
D
ISPLAY AND CONTROL PANEL
CHAPTER 6 OPERATION AND MAINTENANCE
Emergency mode
Whenever a standard software upload of the SMB Controller system software via the SMB Controller
Manager is not possible or has proved faulty, you must carry out an emergency upload. For this purpose
the SMB Controller must be set into the emergency mode.
In emergency mode pattern [14]
is displayed.
Enter emergency mode
1.
Restart the SMB Controller with the Restart button in the SMB Controller Manager System reset
view.
– All applications are closed and the SMB Controller starts up again
OR
Shut-down the SMB Controller with a long click (> 5s) of the pilot key (CTRL)
– All applications are closed and SMB Controller changes into the shut-down mode and stays
there for 1.5 minutes before it starts up again.
2.
Press the pilot key (CTRL) while F0 lights up red during start up (pattern [11]).
– As confirmation the F0 - F6 LED are rapidly flashing red 4 times (pattern [12]).
– The SMB Controller Emergency software is loaded (pattern [13]
).
– The emergency mode is entered and Pattern [14]
is displayed.
[9] Norma
l
mode,
an
error
occurr
ed.
Table 6.8:Enter emergency mode (Sheet 1 of 2)
No. PWR F0 F1 F2 F3 F4 F5 F6 SYS Durat
ion
Mean
ing
[10] ~11s Powe
r is
on,
begin
of
restar
t
Table 6.7:Normal mode with additional information (Continued) (Sheet 2 of 2)
To Next Page
Loading...
Need help?
General
