12-33
3. Install the inspection plug.
4.2 Replacement
1. Remove inspection plug and drain plug to
let the oil flow out.
NOTE:
Oil removal is quicker if performed soon after the
vehicle has been stopped and while the oil is still
hot.
2. The drain plug is fitted with a magnet. Wipe off
any metal particles sticking to the magnet and
install the drain plug.
3. Add oil through the inspection plug hole until it
reaches the bottom of the hole.
Put your finger straightly into the inspection plug
hole after one minute has passed, and check
that the oil is filled up to the opening of the hole.
4. Install the inspection plug.
5 Axle housing gear oil
The first axle housing gear oil replacement during
the run-in period should be performed at the first
4,000 km (2,500 miles).
Tightening torque
68.6 ± 14.7 N·m (51 ± 11
ft.lbs., 7.0 ± 1.5 kgf·m)
WARNING
Do not replace the oil immediately after driv-
ing, as you could be scalded by extremely
hot oil. Give the oil time to cool before drain-
ing it.
Tightening torque
68.6 ± 14.7 N·m (51 ± 11
ft.lbs., 7.0 ± 1.5 kgf·m)
Tightening torque
68.6 ± 14.7 N·m (51 ± 11
ft.lbs., 7.0 ± 1.5 kgf·m)
Inspection intervals
Every 10,000 km
(6,000 miles)
Replacement intervals
Every 30,000 km
(18,000 miles)
FE_FG.book Page 33 Wednesday, January 14, 2009 7:08 PM
To Next Page
Loading...
Need help?
General
