EasyManuals Logo
Home>Mitsubishi>Trucks>2010 Fuso FE

Mitsubishi 2010 Fuso FE User Manual

Mitsubishi 2010 Fuso FE
370 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #98 background imageLoading...
Page #98 background image
6-13
9 ABS warning lamp
This lamp comes on when the starter key is turned
to “ON”. It should go out a few seconds later. If the
lamp comes on again, this indicates there is a mal-
function in the antilock braking system (ABS).
Should this lamp illuminate during driving, stop the
vehicle in a safe place and perform the following
inspection.
1. Turn the starter key to the “OFF” position and
then to the “ON” position again.
2. Determine the system condition as follows:
The system is normal if the warning lamp goes
out a few seconds later.
The system is faulty if the warning lamp stays on
for longer than a few seconds or it goes off but
comes on again.
The system is normal if the warning lamp goes
off in a few seconds after the starter key is
turned to “ON”. The system is also normal if the
warning lamp does not go off a few seconds but
then goes off as soon as the vehicle is started.
3. If the system is found to be faulty, have the sys-
tem repaired by an authorized dealer as soon as
possible.
NOTE:
Even with the ABS faulty and the warning lamp
remaining lit, the normal brake system is still func-
tioning satisfactorily. Only the ABS function is lost.
Drive with great care on slippery surfaces with the
vehicle in this condition.
10 Automatic transmission warning lamp
<Automatic transmission vehicle>
This lamp comes on when the starter key is turned
to “ON”. It should go out in a few seconds.
The illumination of this lamp indicates a fault in the
automatic transmission electronic control system. If
the lamp illuminates, stop the vehicle in a safe
place, turn the starter key to the “ACC” position to
stop the engine, then start the engine again. In cer-
tain circumstances, the on-board computer may
reset itself, allowing normal operation to continue.
If the fault does not rectify itself or the warning lamp
signals abnormal condition again, have an autho-
rized dealer carry out a check.
With the electronic control system malfunctioning,
the vehicle can be driven in a “limp-in” mode
whereby gearshifts will be made per the table
below.
Z10986
Z10839
FE_FG.book Page 13 Wednesday, January 14, 2009 7:08 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi 2010 Fuso FE and is the answer not in the manual?

Mitsubishi 2010 Fuso FE Specifications

General IconGeneral
BrandMitsubishi
Model2010 Fuso FE
CategoryTrucks
LanguageEnglish

Related product manuals