13-25
3.2 Crew-cab models <front and rear seats>
1. Insert a flat-blade screwdriver between the
lens and the interior lamp and use it to
release the tabs on the bottom of the lens.
Remove the lens.
2. Push the bulb retainer rightward and remove
the bulb .
3. To install the lens, insert the tabs on the top of
the lens and press the bottom of the lens into
place.
4 Replacing other lamps
1. Loosen the screw that secures the lens then
remove the lens.
2. Turn the bulb counterclockwise while pressing it
and remove it.
3. Insert a new bulb and turn it clockwise.
4. Fit the lens, ensuring that the packing is cor-
rectly positioned. If the packing is incorrectly
installed or twisted, water can enter the lamp
and shorten its life. If the packing is dirty, clean
it.
5. Uniformly tighten the screws that retain the lens.
Depress the brake pedal harder than usual, down-
shift to use engine braking and activate exhaust
braking to stop the vehicle. Apply the parking brake
when necessary. After the vehicle has been brought
into a stop, check parts, then have an authorized
dealer perform necessary inspection.
When braking is sluggish
WARNING
• Never use the parking brake during driving
except in an emergency. Pulling the park-
ing brake lever with full force while driving
could cause the vehicle to topple over.
• Never continue driving with the brake sys-
tem malfunctioning or leaking fluid.
Z09125
FE_FG.book Page 25 Wednesday, January 14, 2009 7:08 PM
To Next Page
Loading...
Need help?
General
