5-28 Switches and controls
Use the rheostat control switch to adjust the bright-
ness of the meter cluster illumination lamps.
With the meter cluster lamps on, press and hold
either side of the switch to set the lamps to your
desired brightness, then release the switch.
NOTE:
The lamps can be brightened and dimmed only
within a fixed range. Pressing the rheostat control
switch after the lamps have brightened or dimmed
to the limit will have no effect.
<Vehicles other than Crew-cab models>
This switch operates the lighting inside the van
body. With the starter switch in the “ON” position,
operate the van body dome light switch to turn the
van body interior lighting on or off. An indicator light
comes on in the switch when it is in the “ON” posi-
tion.
CAUTION
Leaving the van body interior lighting on for an
extended period without the engine running can
drain the battery.
The mirror stay can be swung manually in the direc-
tion indicated by the arrow.
Swing the stay to the inward position if the mirror is
obstructing free movement of the vehicle, for exam-
ple, when turning a tight corner, passing an oncom-
ing vehicle or parking in a narrow place.
Rheostat control switch
Van body dome light switch
Rearview mirrors
Z14901
Bright
Dim
Z14902
Z14903
FE_FG.book Page 28 Wednesday, January 14, 2009 7:08 PM
To Next Page
Loading...
Need help?
General
