5-22 Switches and controls
• Rotating the grip at the end of the lever activates
the windshield wipers in one of the following
three modes:
INT: Wipers operate intermittently at 3 to 5 sec-
ond intervals.
LO: Wipers operate at a slow speed.
HI: Wipers operate at a rapid speed.
Replace the wiper blades if they start to work inef-
fectively. P. 12-80
CAUTION
Wiper blade rubber can deteriorate over time,
causing the wipers to work ineffectively and
possibly causing the windshield to be
scratched.
• To activate the windshield washer, pull the lever
towards you.
• Refill the washer fluid reservoir before it is
empty. P. 12-81
• If there is washer fluid in the reservoir but none
is sprayed when you operate the washer, the
nozzles may be blocked. Clean the nozzles
using a piece of thin wire. If fluid is still not
sprayed when you operate the washer, have the
vehicle inspected by an authorized dealer.
<Vehicles with cruise control>
Cruise control memorizes any desired speed above
the speeds given below and maintains that speed
automatically without operating the accelerator
pedal. It is especially useful for freeway driving that
involves almost no chances of pulling over and
stopping.
NOTE:
For the sake of safety, do not use the cruise control
in the following driving conditions:
• In heavy traffic which does not allow sufficient
vehicle to vehicle distance
• On roads with sharp turns or poor visibility
Cruise control
Speeds above which cruise control functions
Approx. 57 km/h (35 mph)
Z10723
HI
OFF
LO
INT
FE_FG.book Page 22 Wednesday, January 14, 2009 7:08 PM
To Next Page
Loading...
Need help?
General
