Mitsubishi MA Series User Manual

38
*1. Can be set only when a wired remote controller is used. This function cannot be set for fl oor type models.
When using two remote controllers (two-remote controller operation), the remote controller with a built-in sensor must be set as the main re-
mote controller.
VI. Unit Function Setting by the Remote Controller (for Mr. SLIM P Series)
Each unit’s functions can be set by a remote controller. Setting of each unit’s functions is possible by remote controller only.
Table Functions Available (For details regarding initial settings and operation modes of each unit, refer to the unit installation
manual.)
(1) Itemised functions of the entire refrigerant system (select unit number 00)
Function Settings Mode No. Setting No. Check Remarks
Not available
1
Available
(Approx. 4-minute wait-period after power is restored.)
Average data from each indoor unit
1
Data from the indoor unit with remote controllers
2
Data from main remote controller
3
Not supported
1
Supported
(Indoor unit does not intake outdoor air through LOSSNAY.)
2
Supported
(Indoor unit intakes outdoor air through LOSSNAY.)
3
230V
1
208V
2
Auto energy-saving operation ON
1
Auto energy-saving operation OFF
2
2 C
[
36 F
]
(Normal)
1
3 C
[
37 F
]
2
Standard
1
For high humidity
2
Power voltage
Auto operating mode
*2
Frost prevention
temperature
Defrosting control
Power failure
automatic recovery
Indoor temperature
detecting *1
LOSSNAY
connectivity
2
1
2
3
4
5
15
17
Meaning of "Function setting"
ModeNo.02 : indoor temperature detecting
No Indoor temperature : ta
No1. Average data of the
sensor on all the
indoor units
factory
setting
ta=(A+B)/2 ta=(A+B)/2 ta=A ta=A
No2. the data of the sensor
on the indoor unit that
connected
with remote controller
ta=A ta=B ta=A ta=A
No3 the data of the sensor
on main remote
controller.
ta=C ta=C ta=C ta=C
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
INDOOR
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
OUTDOOR
INDOOR
REMOTE
(MAIN)
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
INDOOR
*2. Can be set only when the outdoor unit is an inverter type.
Perform the following settings only to change the functions for Mr. Slim series.
(This setting is not possible with the City-Multi series.)

Mitsubishi MA Series Specifications

General

Brand	Mitsubishi
Model	MA Series
Category	Remote Control
Language	English