Mitsubishi PLK-E2010R User Manual

- 3 -
3. INSTALLATION
CAUTION
★The machine should be installed by the specialists who have enough experience for the sewing
machine installations.
★All the necessary electric wiring should be done by electric engineers who are qualified for the electric
wiring.
★if any damage or fault is found on the machine at the installation, please do not operate until it is
repaired.
★Please do not operate the sewing machine with excessive modifications from the standard
specification.
3-1 Preparation of the table
If the table is not MITSUBISHI original, the thickness of the table is required to have 40mm more.
And please refer to the cut out table drawing for your own preparation.
The cut out drawing is shown on the last page of this technical manual as APPENDIX drawing.
3-2 Preparation for the steel stand
If the steel stand is not MITSUBISHI original, please refer to the assembling drawing for your own
preparation.
If the steel stand is MITSUBISHI original, please assemble the steel stand with the assembling
instructions enclosed in the packing.
3-3 Installation of the motor
If the motor is purchased without assembling to the table, the motor has to be installed underneath the
table.
Please install the motor with the instructions explained in the paragraph [Installation of the Motor] on the
other CONTROL UNIT
technical manual.
3-4 Installation of the control box
If the control box is purchased without assembling to the table, the control box has to be installed
underneath the table.
Please install the control box with the instruction explained in the paragraph [Installation of the control
box] on the other CONTROL UNIT
technical manual.
3-5 Connection of the operation panel
Please connect the operation panel with the instructions of Operation Panel
Technical manual
enclosed in the packing.

Mitsubishi PLK-E2010R Specifications

General

Brand	Mitsubishi
Model	PLK-E2010R
Category	Sewing Machine
Language	English