Advanced Features
English
34
OR
Use the keypad to enter the required ID.
4 Hold the microphone vertically 1 to 2 inches (2.5 to 5.0 cm)
from your mouth.
5 Press and hold the PTT button to start the Selective Call.
The display shows the ID of the target radio.
6 Release the PTT button to listen.
7 Press H to return to the Home screen.
If you do not press H button to hang up, your radio will remain
in Selective Call state with the other unit. You will miss all
subfleet traffic and incoming phone calls.
Using the Talkgroup Call Feature (Conventional
Operation Only)
This feature allows you to define a group of conventional
system users so that they can share the use of a conventional
channel.
Note: Encryption keys are slaved to talkgroups. When
talkgroups are enabled, encryption keys are changed
by changing the active talkgroup. See Secure
Operation on page 68 for more information.
Selecting a Talkgroup
Procedure:
1 < or > to TGRP.
2 Press the Menu Select button directly below TGRP. The
display shows the last talkgroup that was selected and
stored.
3 < or > to PSET for the preset preprogrammed talkgroup.
OR
< or > to the required talkgroup.
OR
Use the keypad to enter the number of the corresponding
talkgroup in the list.
4 Press the Menu Select button directly below SEL to save
the currently selected talkgroup and return to the Home
screen.
5 If the encryption key slaved to the new talkgroup is erased,
a momentary key fail tone sounds and the display shows
KEY FAIL.
OR
If the encryption key that is slaved to the new talkgroup is
not allowed, a momentary key fail tone sounds and the
display shows ILLEGAL KEY.
6 Press H or the PTT button to exit.
To Next Page
Loading...
Need help?
General
