Advanced Features
English
38
All Active Mode
The All Active mode enables all connected control heads of the
radio to operate concurrently with each other. When you
activate a feature on one control head, the rest of the control
heads will have the same activated feature and indicator on
their respective display.
The multiple control head feature allows only control heads of
the same type to be connected. Upon power up, if a control
head of a different type is connected to the radio, the radio
reports the fatal error CH MISMATCH on the display of all
attached control heads.
Intercom Feature
The All Active mode allows you to use one of the control head to
talk to the user at the other control heads.
Note: Only one intercom call can be initiated at one time.
Procedure:
1 Press the Menu Select button directly below INTC to
activate the intercom feature of any of the control head.
2 Press the PTT button to initiate an intercom transmission.
All control heads that are attached will receive the same
intercom call.
3 The display of the control heads receiving the intercom call
shows the alias/ID number of the transmitting control head.
4 Press the Menu Select button directly below EXIT to
deactivate the intercom feature.
OR
Press H to deactivate the intercom feature.
OR
Change to other mode to deactivate the intercom feature.
OR
Only in Emergency channel:
pressing the Emergency button or the emergency
footswitch on any control head also deactivates the intercom
feature.
One Active Mode
The One Active mode enables only one control head to be
visibly active at a time in a two control head system. In the One
Active mode, if more than two (2) control heads are present
upon power up, the radio shows a fatal error EXTRA CH on the
display of all attached control heads.
The active control head commands the system normally. In the
meantime, the inactive control head is in remote mode with its
display showing REMOTE.
The Volume knob, DIM, Front/Rear (F/R) softkey and
Emergency buttons remain active on the inactive head, while
all other controls are disabled. Emergency footswitch and VIP
inputs are also still active on the inactive control head. However,
VIP inputs must be connected to the head assigned ID #1.
To Next Page
Loading...
Need help?
General
