LED Indicators
Feature LED Indicator
Monitor mode Solid per channel color.
Call tone Momentary solid per channel color.
Scan Cycles through in clockwise direction with one LED lighting
up at one time. LED color changes on the top slot when
each cycle is completed.
Turn on or off Top red and the remaining white LED illuminates briefly.
Advanced radio configuration Blinking green.
Audio jack feedback LED blinks blue when no accessory at power-up.
LED blinks red and purple fast alternatively when accessory
is unplugged.
Volume LED
When volume is increased, Smart Status Glow Ring LED lights up in a clockwise direction from the
bottom left to the bottom right of the LED ring.
The followings are the three levels of LED brightness for each LED when volume is increased:
• Dim
•
Medium
• Maximum brightness
Monitoring Channels
Procedure:
1 To activate the monitor selection mode, press the Menu button and navigate to Monitor
Selection.
If the monitor is off, you hear a voice prompt to activate the monitor mode by pressing the + or -
button.
2 Press + or - button to activate or deactivate the monitor mode.
When the monitor mode is on, you hear static if no activity is present or audio if channel activity
is present.
3 To engage the monitor mode, enable monitor through the menu and let the menu time out.
4 To exit the Monitor mode, press the PTT button.
Scan
You can scan up to 16 channels on CLP446e and CLPe PLUS models.
When the radio detects activity, it stops scanning and locks in on the active channel. This allows you to
listen and talk to the person transmitting without changing channels.
MN006181A01-AA
Getting Started
20
To Next Page
Loading...
Need help?
General
