Radio Cloning
This feature allows you to clone radio settings from one radio to another.
Cloning Radio Settings
You can copy the radio settings from the source to another radio.
You can use one of the following unit chargers and cables for cloning:
• CLP Series Single Unit Charger (SUC) kit part number IXPN4028_
7
and CLP Series Cloning Cable
kit part number HKKN4028_ (optional accessory).
•
Multi-Unit Charger (MUC) Kit Part Number IXPN4029_ (optional accessory)
The MUC does not have to be plugged in for cloning, but both radios require charged batteries.
Cloning Radios using the Cloning Cable
Prerequisites:
• A fully charged battery on each radio.
• Two Single-Unit Charger (SUC) Kits.
• Both radios are turned off.
• Source radio: Radio to be cloned.
• Target radio: Radio to which the configuration of the source radio is to be copied.
A radio which is programmed with the expanded frequencies (446.00625 MHz–446.19375 MHz) does
not support cloning to legacy eight frequency radios.
Figure 12: Cloning the Radio through a Single Unit Charger
Procedure:
1 Unplug any cables such as power supply or micro USB cables from the SUC.
2 Plug one side of the cloning cable micro USB to one SUC and plug the other end to the second
SUC.
7
Revision B onward
MN006181A01-AA
Radio Cloning
33
To Next Page
Loading...
Need help?
General
