2-8
MS-6738 Micro ATX Mainboard
Installing SDR Modules
1. The SDR DIMM slot has 2 Notch Keys “VOLT and DRAM”, so the
DIMM memory module can only fit in one direction.
2. Insert the DIMM memory module vertically into the DIMM slot. Then
push it in.
3. The plastic clip at each side of the DIMM slot will automatically close.
SDR Module Combination
At least one DIMM module should be installed on the motherboard.
Memory modules can be installed on the slots in any order. The single-/double-
sided memory modules that each DIMM slot supports are listed as below:
S: Single Side D: Double Side
Slot Memory Module Total Memory
DIMM 2
(Bank 2 & 3) S/D 64MB~1GB
Maximum System Memory Supported 64MB~2GB
DIMM 1
(Bank 0 & 1) S/D 64MB~1GB
Volt
Notch
MSI Reminds You...
You can barely see the golden finger if the module is properly
inserted in the socket.
To Next Page
Loading...
Need help?
General
