mycom 200VSD User Manual

2205Q2JE-HO-S6-N_2020.01.
Chapter 1 Safety
SCV-series Screw Compressors 1.1 Observation/Prevention
1-2
1.1.1.3 Do's on Lockout/Tagout after Shutting off the Power
 Prepare lockout / tag-out devices for the main breakers in the power lines to the main motor
and control cabinet.
 By applying the lockout/tag-out procedure after turning off the power, you can prevent any
other personnel from restoring the power inadvertently. It enhances the safety of the personnel
working on the power supply equipment and the package.
 If there are any possibilities of danger during work (especially during cleaning, maintenance,
inspection, or troubleshooting), turn the main motor and control power "OFF" and perform a
lockout/tag-out procedure.
 Before working on the package for troubleshooting, setup, cleaning, maintenance and/or
inspection, it is recommended to always perform a lockout/tag-out procedure to the main motor
and control power. It is also recommended to check if the lockout/tag-out procedure has been
performed according to good practice.
 Turn off the power and perform lockout/tag-out before working on the package. Clearly notify
the workers of the necessity of lockout/tagout.
• It is assumed that workers do not perform lockout/tagout of the main motor and control
power before starting work because it is troublesome, and only turn "OFF" the main motor
and control power.
• It is assumed that workers only turn off main motor and control power and do not
lockout/tagout the main motor and control power, because they think it is not important.
 Upon completion of the work, the worker responsible for the lockout/tag-out must remove the
lockout/tag-out device.
1.1.1.4 Do’s about Personal Protective Equipment(PPE)
 Prepare and use personal protective equipment which is in accordance with the area’s safety
standards.
 Check the function of each PPE before use.
 Wear appropriate work cloth and avoid loose clothing.
 Do not wear any neckties or jewelry that can get entangled in the moving or rotating parts. A
helmet is recommended for the protection against head injuries
 Empty your pockets to prevent objects from falling into the machine
1.1.1.5 Do’s about Handling of Hazardous and Toxic Substances
 Obtain Safety Data Sheets (SDS) from manufacturers/suppliers of hazardous and toxic
substances.
 Check the SDS and follow the handling instructions recommended by the manufacturers to
handle and store those substances.
1.1.1.6 Do’s about the Handling Emergency Situations
 Develop an emergency action procedure in accordance with the legal regulations and post it at
a safe and easy to reach place.
1.1.1.7 Do’s about Waste Oil, Fluid, and Materials
 Disposal of refrigerant and waste oil from the compressor are subject to a number of
environmental protection regulations. Follow the local, state or federal acts and regulations as
well as your company's rules, when disposing of such waste oil, fluid and materials.

mycom 200VSD Specifications

General

Brand	mycom
Model	200VSD
Category	Air Compressor
Language	English