National Instruments cDAQ-9133 User Manual

© National Instruments | 1-27
NI cDAQ-9132/9133/9134/9135/9136/9137 User Manual
Figure 1-19. Installing the DIN Rail Clip on the cDAQ Controller
(cDAQ-9132/9134/9136 Shown)
2. Insert one edge of the DIN rail into the deeper opening of the DIN rail clip, as shown in
Figure 1-20, and press down firmly on the controller to compress the spring until the clip
locks in place on the DIN rail.
Figure 1-20. DIN Rail Clip Parts Locator Diagram
Caution Remove the modules before removing the controller from the DIN rail.
Mounting the cDAQ Controller on a Rack
NI offers two rack mount kits, part numbers 779102-01 and 781989-01, that you can use to
mount the cDAQ controller and other DIN rail–mountable equipment on a standard 19-inch
rack. You must order the NI DIN rail mount kit in addition to these kits. Refer to the Cables and
Accessories section for the accessory part number for your cDAQ controller.
1 DIN Rail Clip 2 DIN Rail Spring 3 DIN Rail
1
2
3

National Instruments cDAQ-9133 Specifications

General

Brand	National Instruments
Model	cDAQ-9133
Category	Controller
Language	English