© National Instruments | 1-31
cDAQ-9185/9189 User Manual
Reset Button
The cDAQ chassis is equipped with a reset button.
Pressing the reset button results in the following chassis responses:
• When pressed for less than five seconds, the chassis reboots with the current configuration.
• When pressed for five seconds or longer, the STATUS LED lights. When released, the
chassis reboots into factory default mode, which returns the chassis user configuration to
the factory-set defaults listed in Table 1-6.
Power Connector
The cDAQ chassis ships with the following:
• 2-position power screw terminal connector plug (for use with an external power source)
• Power supply
Note When operating the cDAQ-9185/9189 in hazardous locations, you must use
the power connector with an external power supply rated for hazardous locations.
The power supply included in the cDAQ-9185/9189 kit is intended only for desktop
use. For all other applications use the included 2-position power connector plug and
a power supply rated for your application power requirements. Visit
ni.com to find
hazardous locations-certified power supplies.
Refer to the specifications document for your chassis for information about the power connector.
PFI 0 SMB Connector
Refer to the PFI section of Chapter 5, Digital Input/Output and PFI, for information about the
SMB connector for PFI 0.
Internal Ethernet Switch
Refer to the Internal Ethernet Switch section of Chapter 2, Networking, for information about
the internal ethernet switch.
Table 1-6. NI cDAQ Chassis Default Settings
Attribute Value
Hostname cDAQ918x-<serial number>
IP DHCP or Link Local
Comment Empty
Default Login User name = admin
Password = no password required
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
