© National Instruments | 2-23
RMC-8357 User Manual
sSATA Port
0
~
Port 3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE- SET
initialization to the device. The options are Enabled and Disabled.
Port
0
~
Port 3 sSATA Device Type
Use this item to specify if the sSATA port specified by the user should be connected to a Solid
State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
Server ME (Management Engine) Configuration
This feature displays the following system ME configuration settings.
• General ME Configuration
• Operational Firmware Version
• Recovery Firmware Version
• ME Firmware Features
• ME Firmware Status #1
• ME Firmware Status #2
• Current State
• Error Code
PCIe/PCI/PnP Configuration
The following PCI information will be displayed:
• PCI Bus Driver Version
• PCI Latency Timer
PCI AER (Advanced Error-Reporting) Support
Use this item to configure the PCI-X latency timer for a device installed on a PCI-X bus. Select
64 to set the PCI-X latency timer to 64 PCI clock cycles. The options are 32, 64, 96, 128, 160,
192, 224 and 248 (PCI Bus Clocks).
VGA Palette Snoop
Select Enabled to support VGA palette register snooping which will allow a PCI card that does
not contain its own VGA color palette to examine a video card palette and mimic it for proper
color display. The options are Disabled and Enabled.
PERR# Generation Support
Select Enabled to allow a PCI device to generate a PERR (PCI/PCI-E Parity Error) number for
a PCI bus error event. The options are Enabled and Disabled.
To Next Page
Loading...
Need help?
General
