41
Planar-D1 / Compact-M2 R7
DE
EN
IT
Malfunction and remedy
n WARNING
Risk of injury or damage to property.
`
Work must not be continued with a faulty NBB radio control system!
`
Always contact your dealer or NBB in the event of a fault.
`
Only allow repair work to be carried out by a specialist.
Error Possible cause and remedy
The battery is not inserted correctly or is flat.
→ Replace the battery or check that it is seated correctly.
No response
when switched on
The rechargeable battery is not inserted correctly or is flat.
→ Charge the rechargeable battery or check that it is seated correctly.
The emergency stop switch is not unlocked.
→ Unlock the emergency stop switch.
The transmitter is switched on but not enabled.
→ Press the key.
Individual commands
are not executed
A control element on the transmitter is defective.
→ Have the control element repaired by an authorised specialist workshop.
The output control on the receiver is defective.
→ Have the output control repaired by an authorised specialist workshop.
The machine control is defective, e.g. the cable from the receiver to the device
to be controlled (transmitter and receiver are OK).
→ Have the defective parts repaired or replaced by an authorised specialist workshop.
Customised locking is not released.
→ There are various options/causes here, e.g. dead man's joystick.
Maintenance and care
n CAUTION
Risk of injury or damage to property due to uncontrolled movements
of the system to be controlled.
The system to be controlled becomes incapable of action for a certain period of time.
`
Put the system to be controlled in a safe position.
`
Only clean the transmitter when the power supply is disconnected.
Your NBB transmitter is maintenance-free. Nevertheless observe the following points:
– Regularly check the emergency stop or stop switch for function.
– Regularly check control elements for function/wear.
– Remove building material residues or other dirt.
To Next Page
Loading...
Need help?
General
