English - 33
Power On and Off Modes
Power indicator status
The monitor operates as follows in On mode when no signal is input from an external device.
Mode Normal operation
(On mode)
Auto power save mode
(energy-saving mode)
Auto standby mode
(energy-saving mode)
Power indicator Lit blue Flashing red Lit red
Energy Mode
The three following modes are available on the monitor.
Setup
Move Select
HDMI1
Energy Mode
Power Save
Quick Start
Auto Power Down
Home
OK
Return
MENU
EXIT
EXIT
Retail
Office
LAN and RS-232C can be selected for the monitor control. The way the energy modes operate varies depending on the
selected control method.
When [RS-232C] is selected for control, [Power supply] and [Quick Start] are set to [Off]
Home/Ofce mode
• When no signal is input, “No signal” is displayed and the monitor enters the auto standby mode after a while.
• When a signal is input into the selected input terminal, the On mode is resumed.
When the AV terminal and VGA (YPbPr) terminal are selected, the On mode is not resumed even if a signal is input. In this
case, enable the Quick Start function. (With this function enabled, the On mode is resumed.)
Retail mode
• The monitor does not enter the energy-saving mode when no signal is input. (The On mode is maintained.)
CAUTION During auto standby mode, if the power cord is disconnected and then plugged again, the monitor will be in
the auto standby mode.
To Next Page
Loading...
Need help?
General