NEC MultiSync E658 User Manual

English - 76
Setup
Setup
OSD Settings
Language Select the language used in the OSD.
Transparency Set the transparency level of the OSD menu between 30%, 50%, 70% and Off.
The higher the percentage, the more transparent is the OSD menu.
Information OSD Displays or hides the Information OSD.
Information OSD contains the messages that are displayed on the screen when the input is
switched or when the state of the input signal changes.
Power save settings
Energy Mode SelectamodebetweenHome,Retail,andOfce.
For more information, see “Energy Mode” page 33.
Power Save Sets the time until the monitor enters the Power Save mode. When the set time has elapsed
after the input signal has been lost, the Power Save function is activated.
Quick Start When set to [On], the monitor consumes more power but the display recovery time is
shortened when a video signal is input.
Auto Power Down When turned On, the monitor turns automatically off after 4 hours without any operation.
Auto Input Change When there are several inputs, this function switches automatically to the terminal to which a
signal is input.
Press the INFO button of the remote control to display the selected input terminal on the
Information OSD.
None The input terminal is changed manually.
First If the signal is lost in the input terminal being displayed, the monitor searches automatically
another terminal with an input signal and switches to it.
The display does not change if a new signal is input into a terminal different from the terminal
currently being displayed.
Custom The input terminals included in the search performed by the monitor can be selected.
When the AV terminal and VGA (YPbPr) terminal are selected, the On mode
is not resumed even if a signal is input in the energy-saving mode.
HDMI Settings
CEC This function makes it possible to control a device supporting HDMI CEC connected to the
HDMI terminal.
When set to On, HDMI CEC is enabled.
EDID Sets the HDMI mode.
Mode 0
Max resolution is 1920 x 1080 (60 Hz).
Mode 1
Max resolution is 3840 x 2160 (30 Hz).
Mode 2
Max resolution is 3840 x 2160 (60 Hz), HDCP 2.2, or HDR.
Video Range Adjust the gradation range to be shown according to the video signal to improve the whiteout
and blackout of the image.
HPD Delay This function makes it possible to control the time until the video from the HDMI terminal is
displayed.
When set to Off, the time until the video is output can be reduced but the video may not be
output depending on the device. In such a case, set [HPD Delay] to On.
ENOT

NEC MultiSync E658 Specifications

General

Brand	NEC
Model	MultiSync E658
Category	Monitor
Language	English