1-33
English-4
Quick Installation -
continued
Remove Monitor Stand for Mounting
To prepare the monitor for alternate mounting purposes:
1. Disconnect all cables.
2. Place monitor face down on a non-abrasive surface (Figure R.1).
3. Remove the 4 screws connecting the monitor to the stand and lift off
the stand assembly (Figure R.1).The monitor is now ready for
mounting in an alternate manner.
4. Connect the AC cord and signal cable to the back of the monitor.
5. Reverse this process to reattach stand.
NOTE: Use only VESA-compatible alternative mounting method.
6. This LCD monitor is designed for use with a flexible arm.
Please use the attached screws (4pcs) as shown in the picture when
installing.
To meet the safety requirements, the monitor must be mounted to an
arm which guaranties the necessary stability under consideration of
the weight of the monitor.
The LCD monitor shall only be used with an approved arm (e.g. GS mark).
Figure R.1
Non-abrasive
surface
Thickness of Bracket (Arm)
2.0~3.2mm
Tighten all screws
100mm
Replace screws.
100mm
To Next Page
Loading...
Need help?
General