If you did not change the name of the network during the setup process, look for
the default WiFi network name (SSID) and select it. The default SSID is on the router
label.
4. Enter the router WiFi password.
The default WiFi password (also referred to as the network key or passphrase) is also
on the router label.
5. Click the Connect button.
The device connects to the WiFi network of the router.
Wi-Fi Protected Setup Method Wi-Fi Protected Setup (WPS) is a standard for
easily adding computers and other devices to a home network while maintaining security.
To use WPS (Push 'N' Connect), make sure that all WiFi devices to be connected to the
network are Wi-Fi certified and support WPS. During the connection process, the client
gets the security settings from the router so that every device in the network supports
the same security settings.
To use WPS to connect a computer or mobile device to the WiFi network of the
router:
1. Make sure that the router is receiving power (its Power LED is lit).
2.
Check the WPS instructions for your computer or mobile device.
3.
Press the Reset/WPS button of the router for about 5 to 10 seconds until the WiFi
LED blinks amber.
4. Within two minutes, press the WPS button on your computer or mobile device, or
follow the WPS instructions that came with the device.
The WPS process automatically sets up the device with the network password and
connects the device to the WiFi network of the router.
For more information, see Use
WPS to Add a Device to the WiFi Network on page
63.
User Manual18Connect to the Network and
Access the Router
AC1000 WiFi Router Model R6080
To Next Page
Loading...
Need help?
General
