Specify Your Internet Settings
27
Nighthawk AC1900 Smart WiFi Router Model R7000
• If your ISP did not provide details, you select IPv6 Tunnel. If you are not sure, select
Auto Detect so that the router detects the IPv6 type that is in use. If your Internet
connection does not use PPPoE, DHCP, or fixed, but is IPv6, select Auto Config. For
more information about IPv6 Internet connection, see the following sections.
6. Click the Apply button.
Your changes take effect.
Requirements for Entering IPv6 Addresses
IPv6 addresses are denoted by eight groups of hexadecimal quartets that are separated by
colons. You can reduce any four-digit group of zeros within an IPv6 address to a single zero
or omit it. The following errors invalidate an IPv6 address:
• More than eight groups of hexadecimal quartets
• More than four hexadecimal characters in a quartet
• More than two colons in a row
Auto Detect
To set up an IPv6 Internet connection through auto detection:
1. Launch an Internet browser from a computer or wireless device that is connected to the
network.
2. Type http://www.routerlogin.net or http://www.routerlogin.com.
A login screen displays.
3. Enter the router user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
The BASIC Home screen displays.
4. Select ADVANCED > Advanced Setup > IPv6.
The IPv6 screen displays.
5. In the Internet Connection Type list, select Auto Detect.
To Next Page
Loading...
Need help?
General
