English – 17
04.
On the NEW transmitter press and release the button slowly once
Repeat the procedure for each transmitter to be memorised
7.9 - Deleting all memorised transmitters from the memory
Warning! - This procedure can ONLY be performed if the radio memory has been unlocked.
Table 14 - Transmitter deletion procedure
01.
Press and hold the radio button on the control unit up to Step 02
02.
Wait for LED L4(R) to light up then wait for it to switch off and wait for it to ash 3 times
(
)
03.
Release the button exactly during the 3rd ash
If the memorisation procedure was successful, LED L4(R) on the control unit will ash 5 times
7.10 - Locking / unlocking of the radio memory
This procedure locks the memory, thus preventing the recognition and deletion of radio transmitters.
Table 15 - Procedure for locking/unlocking the radio memory
01. Disconnect the control unit from the power supply
02.
Press and hold the radio button on the control unit up to Step 03
03. Power the control unit again (continue holding
the button down)
(
)
04. After 5 seconds LED L4(R) will emit 2 slow ashes: at this point release the button
( )
5 s L4(R)
05.
(Within 5 seconds) repeatedly press and release the radio button on the control unit to
select one of the following options:
- LED off = Deactivation of the memory lock.
- LED on = Activation of the memory lock.
...
Five seconds after last pressing the button, LED L4(R) will emit 2 slow ashes to signal the end
of the procedure.
5 s L4(R)
To Next Page
Loading...
Need help?
General
