English – 5
01. Dig the foundation and route the electric cable ducting
02. Secure the two anchors to the foundation plate with one
nut above and one below.
Tighten the lower nut in such a way that the
thread protrudes by 25/35 mm.
25 ÷ 35 mm
03. Now cast the concrete to secure the foundation plate.
Before the concrete hardens, make sure the
foundation plate is perfectly level and parallel to the
gate.
04. Allow the concrete to harden.
05. Secure the gearmotor:
a - Remove the top anchor nuts
b - rest the gearmotor on the anchor dowels: make sure
that it is parallel with the gate section
c - t the provided washers and nuts and hand tighten
them
To Next Page
Loading...
Need help?
General
