15
Inserting the Battery into the Camera
First Steps
Removing the Battery
Turn the camera off and confirm that the power-on
lamp is off before removing the battery. To eject the
battery, open the battery-chamber/memory card slot
cover and slide the battery latch in the direction shown
1. The battery can then be removed by hand 2.
• Note that the battery may become hot during use;
observe due caution when removing the battery.
Turning On and Off the Camera
To turn on the camera, press the power switch. The
power-on lamp (green) will light and the monitor will
turn on. To turn off the camera, press the power switch
while the power-on lamp (green) is on.
• If the camera is turned off, hold down c to turn the
camera on in playback mode (A 28).
B Note on the Battery
Be sure to read and follow the warnings for the battery on page iii and the section, “The Battery”
(A 115), before using the battery.
D Auto Power Off in Shooting Mode (Standby Mode)
If no operations are performed for about five seconds in shooting mode, the monitor will dim to
save power. Using any of the camera controls will reactivate the display. If no operations are
performed for about a minute (default setting), the monitor will turn off automatically and the
camera will enter standby mode. If no operations are performed for another three minutes, the
camera will turn off automatically (A 107).
Pressing the power switch, or the shutter-release button, while the monitor is off in standby mode
will reactivate the monitor.
To Next Page
Loading...
