49
One-Touch Portrait Mode
The One-Touch Portrait Menu
Press m in one-touch portrait mode to display the one-touch portrait
menu. In addition to image mode and exposure compensation, portrait
effects (reducing vividness of skin tones, softening overall image) can be set.
1
The options chosen in this menu are stored until [Reset all] (c 125) is performed in
the setup menu.
2
The options chosen in this menu will be reset by switching to other shooting modes.
j Face-Priority AF
• The camera’s ability to detect faces depends on a variety of factors, including whether or
not the subject is facing the camera.
• The camera focuses continuously until a face is detected.
• If the yellow double border blinks when the shutter-release button is pressed halfway, the
camera was unable to focus. Release the button and try again.
• If no face is recognized when the shutter-release button is pressed halfway, the camera
focuses on the center of the frame.
• The camera may be unable to detect faces in the following situations:
- When faces are partially hidden by sunglasses or other obstructions
- When faces take up too much or too little of the frame
k Settings for One-Touch Portrait Mode
• Flash: Changeable
• Self-timer: Available
• Macro close-up: Off
Z Image mode
1
Choose an image size and quality (c 95).
I Exp. +/–
2
Adjust exposure for very bright or very dark subjects (c 99).
B Portrait effect
1
Choose from [Normal], [Brighter] (reduces vividness of skin tones), and [Softer]
(soft effect).
To Next Page
Loading...
Need help?
General
