- Ａ ･ -
Q0340グラフィック用ロゴ
060411デザイン部伊藤
VBA14001-R.3694.A
#692×2
#658
#657×4
J18010
Standard: ±0.04mm (1 scale=0.01mm)
#836A 1K602-832 Screen washer A
0.10mm
#836B 1K602-833 Screen washer B
0.20mm
#836C 1K602-976 Screen washer C
0.05mm
Bottom cover
Bottom cover
･
Mount the bottom cover and x it with two screws (#692), the screw (#658), and four screws (#657).
・
Replace the nder screen with the innity focus check screen (J18394), and use the reference lens (J18010)
and read the value. In case it is out of standard, increase or decrease washers (#836A, #836B, or #836C) for
adjustments. * Supply the power (Battery or EH-5) for checking.
Caution: When (J18394) is put in to replace the nder screen, put it with the silver spacers upward, which are
attached on both sides.
∞ Innity focus inspection & adjustment
Reference line
"0" position
To Next Page
Loading...
Need help?
General
