7368 ISAM ONT E-240W-A Product Guide Configure an E-240W-A indoor ONT
Issue: 01 3FE-46974-AAAA-TCZZA 97
Procedure 24 GRE Tunnel configuration
1 Select Network > GRE Tunnel from the top-level menu in the EPON Home Gateway window,
as shown in Figure 40.
Figure 40 GRE Tunnel window
Table 26 describes the fields in the GRE Tunnel window.
Table 26 GRE Tunnel parameters
Field Description
Tunnel Name Choose Create new GRE Tunnel, or Choose an existing tunnel from the
drop-down menu.
The tunnel name is automatically assigned by the system.
Up to 3 GRE tunnels are supported.
WAN Interface Choose a WAN interface from the drop-down menu.
GRE tunnels can only be created on HSI-enabled WAN interfaces.
Primary Remote End
Secondary Remote End (optional)
Enter an IP address or FQDN that is unique in the system.
If the primary remote endpoint is down or unreachable, the secondary
remote endpoint becomes active, if configured.
The secondary remote endpoint remains active until it becomes
unreachable, in which case the primary remote endpoint becomes active
again. Revertive mode is not supported.
If both endpoints are unreachable, the GRE tunnel is declared down.
(1 of 2)
Release 06.00.00h | January 2019 | Edition 08
To Next Page
Loading...
Need help?
General
