RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
RADIUS Attributes Reference
Issue: 01 3HE 10793 AAAB TQZZA 01 129
Notes:
1. Only for new sessions. Ignored for existing sessions.
2. The update will be applied to an existing session at the next DHCP/DHCPv6 Renew or Router
Advertisement (RA).
3. May be present in re-auth or CoA but cannot change for an existing BRG.
4. Mandatory in CoA (used as key to identify the BRG).
2.2.12 Dynamic Data Services
Table 39 Dynamic Data Services (Description)
Attribute ID Attribute Name Description
1 User-Name (RADIUS authentication of data triggered Dynamic Data Services only)
The user to be authenticated in the Access-Request. The attribute value
is the dynamic service data trigger sap-id.
2 User-Password (RADIUS authentication of data triggered Dynamic Data Services only)
The password of the user to be authenticated. The attribute value is
preconfigured: configure service dynamic-services dynamic-
services-policy dynsvc-policy-name authentication password
password
4 NAS-IP-Address (RADIUS authentication of data triggered Dynamic Data Services only)
The identifying IP Address of the NAS requesting the Authentication.
Included when the RADIUS server is reachable via IPv4. The address
is determined by the routing instance through which the RADIUS server
can be reached:
"Management" — The active ipv4 address in the Boot Options File (bof
address ipv4-address)
"Base" or "VPRN" — the ipv4 address of the system interface
(configure router interface system address address).
The address can be overwritten with the configured source-address
(configure aaa radius-server-policy policy-name servers source-
address ip- address).
8 Framed-IP-Address (RADIUS authentication of data triggered Dynamic Data Services only)
The IPv4 source address of an IPv4 data trigger frame that resulted in
the authentication. Not included if the data trigger frame is not an IPv4
packet.
32 NAS-Identifier (RADIUS authentication of data triggered Dynamic Data Services only)
A string identifying the NAS originating the Authentication request. The
attribute value is the system name of the router: configure system
name system-name
To Next Page
Loading...
Need help?
General
