151
Configuring for wireless bridge/repeater
operation
Before you can use Nokia access points as
bridges, you need to configure them manually
to:
• tell them specifically which other access
points are available as bridge partners
• ensure that no loops are created.
Step-by -step procedure
Gathering the information
Before you connect and configure your
network, make sure you have all the necessary
information to hand:
1 Draw a topology map, showing all the
Nokia A032s you plan to include in the
bridge/repeater function.
2 On the map show the bridge partner
relationships and make sure that there are
no loops.
In the example below, involving four access
points, A and D act as wireless bridges. B
acts as a wireless bridge and repeater,
having a local LAN attached. C acts only as
a repeater:
A032-Adv.book Page 151 Monday, November 13, 2000 10:47 AM
To Next Page
Loading...
Need help?
General
