190
Nokia A032 Advanced User Guide
Resetting factory defaults
If you don’t know the Nokia A032’s current
configuration status and you want to ensure
that you are starting from a clean and known
state, you can restore the factory default
settings.
You might want to do this before using Learn
mode to configure the Nokia A032.
Assuming the Nokia A032 is not security
locked (see page 79 and page 45) you can use
the following procedure:
1 Put the Nokia A032 into Learn mode (see
the Getting Started guide).
2 Hold in the
mode button.
The LEDs perform a binary count, slowly
coming on from left to right.
3 Keep holding the
mode button until all the
LEDs are on. This takes about 10 seconds.
The unit has now overwritten the configuration
with the factory defaults; it should restart.
Remember to hold the
mode button again when
the unit restarts if you want to return to Learn
mode.
A032-Adv.book Page 190 Monday, November 13, 2000 10:47 AM
To Next Page
Loading...
Need help?
General
