Nokia A032 User Manual

156
Nokia A032 Advanced User Guide
11 To check that the connections are working,
go to the wireless status screen in the web
interface or use the CLM
show a command.
The bridge partners should be shown by
their user-friendly name and listed as Is
Bridging. It may take up to 30 seconds
for the bridge partners to connect.
Restarting bridges and repeaters
If one or more of the Nokia A032s is restarted,
bridging information will be temporarily lost.
This may result in loss of communication in the
network for up to 5 minutes until the
information is re-learned from the network.
Associated CLM commands
• bridge list – shows any bridge partners
associated with the current access point
•
bridge add – adds the MAC address of a
new bridge partner to the bridge list
bridge add MAC Name
• bridge delete – deletes a bridge partner
from the current access point
bridge delete MAC Name
Setting up bridges using WEPGen
You can use the WEPGen utility to specify to
the access point which devices are peer bridges.
See Using the WEPGen utility on page 163.
A032-Adv.book Page 156 Monday, November 13, 2000 10:47 AM

Nokia A032 Specifications

General

Brand	Nokia
Model	A032
Category	Wireless Access Point
Language	English