Nokia A032 User Manual

155
An example using Telnet
To set up bridge partners as shown in the last
figure, via Telnet, you would proceed as
follows:
1 Connect to access point A (IP address
192.168.0.1).
2 Enter the following command:
bridge add 00e003008192 bridgeB
3 Connect to access point B (IP address
192.168.0.2).
4 Enter the following commands:
bridge add 00e003001234 bridgeA
bridge add 00e00300a04c bridgeC
5 Connect to access point C (IP address
192.168.0.3).
6 Enter the following commands:
bridge add 00e003008192 bridgeB
bridge add 00e00300bc12 bridgeD
7 Connect to access point D (IP address
192.168.0.4).
8 Enter the following command:
bridge add 00e00300a04c bridgeC
9 You can use the command bridge list
to show the entries. Also you can use the
command
bridge delete to remove
entries made in error or no longer required.
10 When you’ve specified all the entries, restart
the Nokia A032s.
The connections should be established.
A032-Adv.book Page 155 Monday, November 13, 2000 10:47 AM

Nokia A032 Specifications

General

Brand	Nokia
Model	A032
Category	Wireless Access Point
Language	English